Read on S3D forums about fan overrides and how to tune it properly. That can't happen without more heat, less speed, or adjusting pretty much everything.īlip fans, disable that, will create a small slowdown on the machine of 500 millisecs, your um2 fans already have a kickstart by firmware. Ok Because the 'Auto' of the previous image you are extruding 0.96mm for a 0.8 nozzle, and that 0.96 will get multiplied by 125% (a 25% extra) making a width of 1.2mm for a 0.8 nozzle. I use this setting to play with some experiments, as soon you go beyond 25% you get blobs and overextrusion on the same spot that makes bad quality. Outline overlap to 32%, that will only make a mess, more than 20% it's too much. Retraction speed 40mm/s, cura uses 25mm/s as default. 'Auto' doesn't do anything auto, it could be nice if it where a real auto settting, but isnt. Retraction distance 1mm only? For PLA Cura does 4.5mm as standardĮxtrusion Width, remove the auto, change it to 0.80mm (same as nozzle) or lower (0.75mm should give you a better look, but I personally only use lower nozzle size to adjust it. There's quite a few basic stuff wrong here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |